Throttle control

1 -	Throttle control

1	Throttle control

2

3	Throttle opening cable

4

5	Left handgrip

6	Throttle closing cable

Parts catalogue


1100	HANDLEBAR AND CONTROLS
1100S	HANDLEBAR AND CONTROLS

Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear in the figures near the text.

Adjusting the throttle cable

To see how to adjust throttle cable, please refer to Sect. D 4, Adjusting the throttle cables.

Disassembling the throttle control


Operations	Reference - See Section
Remove the right hand guard/rear-view mirror assembly	E 1, Removing the hand guard - rear-view mirrors

Slip off the rubber gaiter (A) of the throttle control cables.

Loosen screws (4) securing the two throttle control shells (1) and open them.

Remove the cable nipples from their seats and take the opening (3) and closing (6) cables off the pulley.

Remove the throttle control (1) from the handlebar.

To change the throttle control cables, you need to remove them from throttle body as specified under Sect. L 6, Removing the throttle body.

Spare throttle control cables come complete with adjusters.

Reassembling the throttle control

Grease the ends of the throttle control cables (3) and (6) and the pulley with the specified grease.

Refit throttle control components following the removal procedure in the reverse order; set pin (B), located on throttle control top cover, into the relevant recess (C) on handlebar.

See the figures at the end of the section for the correct routing of the throttle control cables.

Choke/throttle cables routing