Service Tools

4 -	Service Tools


Workshop special tools


Part No.	Description
88700.5644	Tool to set belt roller ring nut for camshaft
88713.2107	Reaction tool to tighten timing belt rollers
88713.2676	Head nuts tightening tool
88713.2103	Support for head assembly
98112.0002	Timing degree wheel
88713.0123	Timing check tool
97900.0215	DDS (Ducati Diagnosis System) + kit for measuring cylinder vacuum
88713.0137	Crankshaft sprocket stop tool
88765.1058	Valve lift gauge
88765.1000 88765.1005 88765.1006	0.1 mm fork feeler gauge 0.2 mm fork feeler gauge 0.3 mm fork feeler gauge
88713.2362	Tool to fit spring and closing rocker arm
88713.2009	Tool to lock belt rollers
88713.0262	Pin to fit the rocker arms
88713.0844	Drift to fit split rings
88713.2011	Crankshaft locking tool
88700.5749	Cap for closing the crankcases
88713.1091	Plate for gear selector fork positioning
88713.1749	Puller for drive belt roller and cover
88765.1297	TDC check gauge
88713.1994	Rocker arm shaft puller
88713.2556	ATPC system clutch housing locking tool
88713.2591	Clutch screw
88713.1010	Exhaust gas pick-up point
88713.1215	Timing belt tensioner
88713.2036	Generator locking tool for nut tightening
88713.2092	Primary gears puller
88713.0879	Valve guide extraction tool
88713.0874	Exhaust valve guide drift
88713.0875	Intake valve guide drift
88713.1078	Drift to install exhaust valve seat
88713.1079	Drift to install intake valve seat
88713.2422	Wrench for tightening the primary sprocket ring nut


Workshop special tools


Part No.	Description
677.4.003.1A	Chain joint
88713.1072	Bottom yoke bearing drift
88713.1344	Chain assembly tool
8000.70139	Front wheel shaft tool
88713.1096	Fork overhaul tool - for fitting the seal
88713.1515	Frame/engine support
88713.1058	Tool to fit steering tube top bolt
88713.1062	Tool to fit steering tube bearings