Stands

5 -

1	Side stand

2

3	Stand plate

4

5

6

7

8

9

10

Spare parts catalogue


Stands

Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear in the figures near the text.

Removing the side stand

Disconnect the connector (A) of the side stand switch (5) from the main wiring harness.

Undo the two screws (2) that secure stand plate (3) to engine. Remove the complete side stand.

Disassembling the side stand

Unscrew the retaining screw (4) and remove the stand switch (5).

Unhook the stand return springs (6) from the pin located on the stand plate (3) and remove the springs.

Unscrew the pivot (8) retaining the stand to the plate and remove the side stand (1) and the nut (9).

Inspecting the side stand

Fit the stand to the plate and check for exceeding play. Ensure that the ends of the stand are not bent with respect to the shank. A stand which shows signs of cracking must be replaced immediately.

See Sect. P 6, Checking protection and safety devices components, for switch (5) testing.

Reassembling the side stand

Grease the stand (1) and fit it to the plate (3). Secure it with pivot (8) and nut (9). Tighten the pivot (8) to the specified torque (Sect. C 3, Frame torque settings).

Position the stand return springs (6), fix them to the pivot of plate (10) and to the stand (1) and tighten.

Position the switch (5) to pivot (8) on the plate.

Fit the retaining screw (4) and tighten to the specified torque (Sect. C 3, Frame torque settings).

Refitting the side stand

Position the side stand plate (3) to the frame. Apply the specified threadlocker to the threads of the two screws (2) and start the screws in their holes.

Tighten the screws (2) to the specified torque (Sect. C 3, Frame torque settings).

Connect the connector (A) of the side stand switch to the main wiring harness.

See the tables in Sect. P 1, Arrangement of wiring on frame, for side stand switch cable routing.