Gear change control

5 -	Gear change control

1	Pivot bolt

2	Gear change pedal

3

4	Rubber block

5

6

7

8	Ball joint

9

10	Actuating rod

11

12

13	Ball joint

14	Gear small lever

15

16

17

Spare parts catalogue


Gearchange lever - foot rest

Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear in the figures near the text.

Removing the gear change control

Unscrew and remove the retaining pin (1) of the gear change pedal (2), collect the washer (6) and the O-rings (17).

Unscrew and remove the screw (16) securing the small lever to the gearbox shaft.

Withdraw the small lever (14) together with the gear change control assembly.

Mark small lever (14) position relative to the gear selector shaft.

To remove the small lever (14) from the gear change control assembly, unscrew the screw (15).

Disassembling the gear change control

Please refer to the exploded view at the beginning of this section for indications on disassembly and replacement of gear change control components.

If the bush (5) inside the pedal (2) needs replacing, drive the replacement bush in place using a press. The bush must be seated 2 mm deep below pedal outer face.

After servicing the gear change control, check the gear change pedal position.

To adjust the gear change pedal, follow the instructions provided in Sect. D 4, Adjusting the position of the gear change and rear brake pedals.

Refitting the gear change control

To refit, reverse the removal procedure.

On refitting, always renew O-rings (17).

Apply threadlocker to the screw (16), the pin (1) and the screw (15) and then tighten them to the specified torque (Sect. C 3, Frame torque settings).