Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear in the figures near the text.

Before performing the frame dimensional checks, you will need to remove a number of components to give all-round access to the frame. See the specific instructions in the relevant sections.

The following diagram shows the components you will need to remove in the correct removal order and the sections giving relevant instructions.

A 315 mm

A1 32 mm

A2 205.3 - 205.8 mm

A3 100 mm

B 692.5 mm

B1 239.5 mm

C2 100 - 100.3 mm

D 54.961 - 54.991 mm

D1 15 mm

α 24° ÷ 24°18’

Badly damaged frames must be changed, not repaired. Any changes to the frame might cause danger. Changes can also break E.E.C. directives on Manufacturer’s liability and general product safety.

Once the frame has been checked, reassemble the motorcycle following the procedures described in the diagram and in the relevant paragraphs, in the reverse order.