Stands

5 -

1	Side stand

2

3	Stand plate

4

5

6

7

8

9

10

11

Parts catalogue


1100	STANDS
1100S	STANDS

Bold reference numbers in this section identify parts shown in this exploded view diagram. These parts do not appear in the figures near the text.

Removing the side stand


Operations	Reference - See Section
Remove the complete left footpeg plate	H 4, Removing the footpegs

Disconnect the stand switch connector (5) from main wiring harness (please refer to Sect. P 1, Arrangement of wiring on frame).

Loosen screw (2) retaining mounting plate (3) securing stand to engine and remove the complete side stand, remove the washers (11).

Disassembling the side stand

Unscrew the retaining screw (4) and remove the stand switch (5).

Unhook the stand return springs (6) from the pin located on the stand plate (3) and remove the springs.

Unscrew the pivot (8) retaining the stand to the plate and remove the side stand (1) and the nut (9).

Inspecting the side stand

Fit the stand to the plate and check for exceeding play. Ensure that the ends of the stand are not bent with respect to the shank.

A stand which shows signs of cracking must be replaced immediately.

See Sect. P 6, Checking the side stand switch, for switch (5) testing.

Reassembling the side stand

Grease the stand (1) and fit it to the plate (3). Secure it with pivot (8) and nut (9).

Tighten the pivot (8) to the specified torque (Sect. C 3, Frame torque settings).

Position the stand return springs (6), fix them to the pivot of plate (10) and to the stand (1) and tighten.

Position the switch (5) to pivot (8) on the plate.

Fit the retaining screw (4) and tighten to the specified torque (Sect. C 3, Frame torque settings).

Refitting the side stand

Fit the plate (3) supporting stand to frame and install screw (2), with washers (11) applying recommended threadlocker.

Tighten the screws (2) to the specified torque (Sect. C 3, Frame torque settings).

Connect the connector of the side stand switch (5) to the main wiring harness.

See the tables in Sect. P 1, Arrangement of wiring on frame, for side stand switch cable routing.


Operations	Reference - See Section
Refit the complete left footpeg plate	H 4, Refitting the footpegs